Current position: Home - Research results - Paper
Regenerable CuO-Based Adsorbents for Low Temperature Desulfurization Application
Release time:2019-03-09 Hits:
Indexed by:期刊论文
First Author:Liu, Dai
Correspondence Author:Zhang, YC (reprint author), Dalian Univ Technol, Sch Chem Engn, Dept Catalysis Chem & Engn, State Key Lab Fine Chem, Dalian 116024, Peoples R China.
Co-author:Chen, Shaoyun,Fei, Xiaoyao,Huang, Chunjie,Zhang, Yongchun
Date of Publication:2015-04-15
Journal:INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH
Included Journals:SCIE、EI、Scopus
Document Type:J
Volume:54
Issue:14
Page Number:3556-3562
ISSN No.:0888-5885
Abstract:A series of CuO-based adsorbents for deep removal of H2S at low temperature was prepared by a coprecipitation method. It was found that CuO-based adsorbents are able to remove H2S from a CO2 stream to less than 0.1 ppm at 40 degrees C. Among them, Fe-Cu-Al-O adsorbent exhibited the highest breakthrough capacity of 113.9 mg g(-1), which is more than 6 times that of pure CuO. The breakthrough capacity was also dependent on the adsorption temperature, space velocity, balance gas, and calcination temperature. The proper adsorption temperature should be lower than 100 degrees C in the presence of CO2, and a higher space velocity and calcination temperature could decrease the breakthrough capacity significantly. In addition, the CuO-based adsorbents had a regeneration rate of 43-90% in air at a relative low temperature from 100 to 200 degrees C with a stable breakthrough capacity after four adsorption-regeneration cycles.
Translation or Not:no